Ameba Ownd

アプリで簡単、無料ホームページ作成

ESD Products Manufacturers

The problems that should be paid attention to when choosing anti-static floor

2021.02.26 05:58

The following points should be paid attention to when choosing anti-static raised floor in the construction of the computer room:

1. First, the total area (or number of blocks) of the anti-static floor required for the construction of the computer room and the number of various accessories (standard ratio 1:3.5, 1:5.5) must be accurately left, so as to avoid waste Or shortage.

2. Fully understand the variety and quality of the anti-static floor produced by the manufacturer, as well as various technical performance indicators. The technical performance of anti-static floor mainly refers to its mechanical and electrical properties. The mechanical properties mainly consider its load-bearing capacity and wear resistance. Install the whole piece of anti-static floor on the overlapping truss beams. After leveling the anti-static floor, its load-bearing capacity should reach a uniform load greater than 1000kg/m2, and the concentrated load of any part of the anti-static floor should be greater than 300kg. When bearing a load of 300kg on a 6cm loading point, the deflection should be less than 2mm and there is no permanent deformation. The adjustable support should be able to withstand a vertical load of more than 1000kg, and the board surface should have a certain degree of abrasion resistance.

Electrical properties are mainly system resistance, electrostatic voltage, and surface resistance. The system resistance should be 105Ω-108Ω. When the temperature is 21±1.5℃ and the relative humidity is 30%, the electrostatic voltage of the anti-static floor should be lower than 2500V, and the surface resistance value should be 105Ω-108Ω.

3. The weight of the heaviest equipment in the computer room should be used as the basis to determine the load of the anti-static floor, which can prevent some equipment from being too heavy and causing permanent deformation or damage to the floor.

4. The anti-static floor has little change due to the influence of external environmental conditions. That is to say, there will be no obvious expansion or contraction due to the excessively high or low external temperature, that is, when the temperature in the machine room is slightly higher, the anti-static floor stretches and expands and cannot be removed and replaced; when the temperature is low, the anti-static floor shrinks and creates a sense of looseness. The shrinkage of the anti-static floor affected by the environment should be less than 0.5mm, and the deflection of the board surface should be less than 0.25mm.

5. The surface of the anti-static floor should be non-reflective, non-slip, corrosion-resistant, dust-free, dust-free, and easy to clean.