Installation manual rubber expansion joint

rubber expansion joint torque values

INSTALLATION INSTRUCTIONS - Rubber Expansion Joints (REJ). Mating Flanges • Install the REJ against the mating flange. It is recommended to install bolt Another convenient method is to cut the lifting pipe longer than the joint, and lift it by means of a chain or cable running through the pipe. It is preferable17. Page 3. Proco Products, Inc. Page 2. 2012 IOM Spool Type ITR. 1.0 Introduction: Proco Products, Inc. (Proco) rubber expansion joints are flexible connectors Rubber Expansion Joint Installation Instructions. Typical Tools required installing a rubber expansion joint. Appropriate Lifting gear; always lift on both Inspect the location—In most cases, rubber expansion joints should be installed close to the main anchor point in order to better absorb the expansion and Senior Flexonics Expansion Joints are fully inspected at the factory and are packaged to arrive at the job site in good condition. Piping must be supported so the expansion joints do not carry any pipe weight. Mating Flanges: 1. Install the expansion joint against the mating pipe flanges Start installation of the expansion joint only once all work on the adjacent piping (flanges welding, anchors setting, etc.) has been completed and cooled down.