Manual heater hose cut off valve

7. The heater hose valve-pressure regulator tee. This unit replaces the temperature switch in the auto unit. This heater hose must be replaced with new hose and connected into place on the manual Just seal off the one line that is not needed. This will be the line coming from the tank body itself. Install a manual shut-off valve that conforms with European Standard Codes of Practice, and a sediment trap/drip leg and union located outside the heater panels, see 8. Shut off the gas supply to the heater. 9. Disconnect the manometer hose. 10. Tighten the small screw inside the pressure tap. • Thermal Cut-Off. A one shot heat sensing fuse that's normally closed and sends power to the thermostat. When tripped by excessive heat (190°F), (i.e. blocked burner or flue tube) a combination of hoses and valves that can aid in the winterization of the water heater. Canadian Gas Association. See instruction manual before setting temperature at water heater. Feel water before bathing or showering. Attach a garden hose to the drain valve on the water heater and direct the stream of water to a drain. DANGER: Before manually operating the relief valve, make certain no one will be Cut off your water at the road or the PRV valve and measure where you need to cut the hard pipes to be able to install the flex kit, to hook your water Read the new heater's manual. It might say something different. Go by the manual at any point that is not the same. Shut off power to the heater Shut-off valves, also called supply stop valves, allow people to connect supply lines to sinks and toilets. They also help isolate and repair leaks If removing a solder-type valve, cut the supply line with a pipe cutter. Leave enough room between the escutcheon plate and the cut to allow installation • Heater must be turned off while re-fueling. • Install heater so it will maintain a minimum distance of 2" from any flammable or heat sensitive material. a. Cut tractor's heater inlet hose and install pipe fittings, elbow, tee fitting and hand valve. b. From the hand valve, connect and route a new coolant Replace Water heater drain valve with ball valve Easier flush and clean out Full open position lets you insert 1/4" copper pipe flushing tool. Then attach garden hose to valve. Prevent water from being drawn into home from outdoor hose Each time water is turned on inside home, the pressure from Turn off the manual shut-off valve if the water heater has been subjected to overheating, fire, flood, physical damage or if the gas supply fails to shut off. ? Read this manual entirely before installing or operating the water heater. ? Use this appliance only for its intended purpose as described in this This manual contains instructions for the installation, operation, and maintenance of the gas-fired water heater. It also contains warnings throughout the manual that Carefully plan the location of the loops and straight sections of hose prior to cutting hoses. If necessary, secure the hoses to the side of the 2 Pressure cut-off valve Z2,Z3 Connection - tank 3 Secondary valves LS LS signal to pump. Chapter 4 Page 9 from 66. Hydraulics Workshop Manual Training Center 1504/1604 LC Date: November 2005. 6.5 Secondary valve with pressure cut in stage.