Hard drive installation manual
Figure 1: easystore Portable Hard Drive Kit Components easystore portable hard drive, with WD Discovery software (includes WD Backup and WD Drive Utilities) USB cable Quick install guide Optional Accessories For information about optional accessories for WD products, visit www.doorway.ru Operating System Compatibility. Preparing for Installation 1–2 SATA Hard Drive Installation Guide Disassembling the Computer 1. Turn off the computer and any external devices. 2. Disconnect the AC power cord and any external devices. 3. Unlock the external chassis keylock (if applicable). 4. If necessary, loosen the screws on the computer to remove the access panel or computer cover. 5. partition and format your hard drive, see your DOS manual for installation instructions. Caution: If you do not install DOS exactly as described below, the DOS setup routine will reformat the hard drive to less than the full capacity. 1. Remove any disk from the floppy drive. 2. Press CTRL+ALT+DEL to reboot the system. The following message displays if EZ-Drive is File Size: KB.
Hard drives The computer supports installation of two inch SATA hard drives in the internal HDD cage. Removing the inch hard drives 1. Perform Pre-installation instructions on page 5. 2. Disconnect the power and data cables from the hard drives. installation. Damage to hard drives is typically caused by rough handling, shock, vibration, or electrostatic discharge (ESD). Be aware of the following precautions when unpacking and handling your hard drive: • Save the packing materials in case you need to return your hard drive. • Allow the hard drive to reach room temperature before opening. External DVR expander and internal hard drive installation instructions. DirecTV Expander Installation Instructions DISH Network Expander Installation Instructions $ Shipping on all Orders Within United States via USPS!
Set “Hard Drive Boot Priority” Your system is now configured with two bootable drives. In order to boot from your new SSD drive, you must enter the system BIOS to set "Hard Drive Boot Priority" so that your new SSD drive is set to boot first. Perform the following: 1. Restart your computer. While the system is restarting, activate the system setup. On a SATA hard drive, position of the drives on the cable does not matter at all because a SATA cable only accomodates one drive. Plug the system in and turn it on. It is best to leave the case cover off for now in case you need to fiddle with something or troubleshoot the installation. DESKTOP. Mount the drive as described in your Mac product manual. Mounting screws and cables should be supplied internally on your Mac. Boot into the Apple desktop. The drive will be auto-detected by the system, and should display a message stating the disk you inserted is not readable by the.