Econominder water softener manual

B) Excess water in brine tank. A) Check salt usage and salt setting. B) See problem #7 Ponds Water Features • Swimming Pools Spas • Well Water Sytems • Water Treatment • Wastewater • Rainwater Harvesting Fleck Model Econominder Trouble-Shooting Guide PROBLEM CAUSE CORRECTION Softener fails to regenerate Softener delivers. FLECK® // Service Manual • 3 INSTALLATION START-UP Water Pressure A minimum of 25 pounds ( bar) of water pressure is required for regeneration valve to operate effectively. water softener. Location Of Softener And Drain The softener should be located close to a drain to prevent air breaks and back flow.  · Years ago an installer left us a service manual for a model Econominder for our new softener, but the dials in the manual don’t quite match those of our softener. The installer is out of business. We use too much salt. Help! Our softener has only one dial that is actually labeled. It is numbered (X ).

AquaSoft / Econominder WATER SOFTENER MANUAL [PDF] Autotrol Pentair Water Softeners Water Conditioner Manuals, Logix™ Controllers. Above: the Autotrol Logix TC softener control, also sold as Pentair i/TC - the manual for this control is given in the list below. MODEL Downflow - Capital Water Softener Inc Service www.doorway.ru Job Specification Sheet Printed in U.S.A. installed ahead of the water www.doorway.ruON OF SOFTENER AND DRAIN: The softener should be located close to a drain. MODEL ECONOMINDER Read Full Source. / Econominder Owner's Manual For questions or in case of emergency, please call turn the manual regeneration knob clockwise until it reads "REGEN." The brine tank should be located within 20 feet of the water softener. Drain cannot be elevated more than 36 inches or exceed 20 feet in length.

MODEL ECONOMINDER Installation Instructions The water softener should be installed with the inlet, outlet and drain connections made in accordance with manufacturer’s recommendations and to meet applicable plumbing codes. 1. Remove control box cover. 2. Make “Time of Day” setting and set “Program Wheel.” (See time control instructions). The softener should be located close to a drain to prevent air breaks and back flow. BY-PASS VALVES Always provide for the installation of a by-pass valve if unit is not equipped with one. CAUTION Water pressure is not to exceed psi ( bar), water temperature is not to exceed °F (43°C), and the unit cannot be subjected to freezing. • This manual is intended as a guide for service of the valve only. System installation requires information from a number of suppliers not known at the time of manufacture. This product should be installed by a plumbing professional. • This unit is designed to be installed on potable water systems only.