Keensert installation manual

Installation Instructions: Installation Procedure: Drill out the old threads using the recommended standard drill size. Chamfer the hole using a countersink tool. In addition to being a cosmetic feature, the chamfered surface also helps to control the depth of the insert during installation. Tap the insert installation threads in the housing using the recommended standard tap size. Threaded inserts, installation as described but before locking the keys in position, mark the key positions, remove insert and pre-broach key slots with broaching tool. Available for external thread M5 and up. Removal: 1. Drilling 2. Defl ect kees 3. Remove insert 4. Insert new Dimensions see inward and with E-Z OUTFile Size: KB. This specification shall be applicable whenever the installation of key-retained inserts and studs is invoked per section , “Usage”. USAGE. This process specification shall be called out on the engineering drawing by using a drawing note. For example: INSTALL KEY-RETAINED INSERTS PER NASA/JSC PRCMissing: keensert.

with a hammer or under a press, remove the tool and install the. In some cases it may be necessary to run the tap back down the hole to clear out any burrs. Available for external metrical thread M5 and up and external imperial thread 1/4“ and up. Release June Installation Instructions Removal: 1. Drilling 2. Deflect kees 3. Insert Installation 1. Drill with a standard drill, as listed for each part number. 2. Countersink with a standard countersink (82° to °). 3. Tap with a standard Unified Thread Series tap. 4. Screw in insert with fingers or installation tool. Insert is designed to stop at the correct depth below the surface of the casting. 5. Installation and Removal Installation Drill out old threads with a standard drill. Note: Drill is oversize — see charts for proper dimensions. Chamfer the hole with a standard countersink (82°°). Tap new threads with a standard tap. See charts for proper size and depth. Screw in the insert until slightly below surface. Drive keys down with.

To connect or set in position and prepare for use. To connect or set in position and prepare for use. In computer terminology, install usually refers to putting software on a computer (install the software), or adding hardware components to. Intermatic timers are popular among home and business owners. These timers control when an appliance or lighting system switches on and off. For those who have a problem with leaving the lights on, Intermatic timers are a great solution. Ke. Westinghouse, a major global corporation that makes electronics, lighting and supplies power, offers both consumers and businesses an enormous array of products and services. Inevitably you'll need a manual for a Westinghouse product. Here'.