Should i mount my own bindings

If you buy used skis then remounting may be something you need to do depending on how different your boot size is compared with the skis previous owner. Typically you can adjust ski bindings one size larger or one size smaller without have to re-drill holes.

Yes, if your child is moving up by one boot size, then you should be able to make the adjustment without remounting. In most cases, a skilled technician will be able to unplug the old holes and re-position your bindings to where they originally sat.

If in doubt. If you want a more detailed run-through read this. While different ski techs have their own rule of thumb. They drilled various holes through ski and measured the pullout strength across a range of distances. The found that drilling a new hole beyond 7mm from the existing hole, maintained maximum strength.

Here is a link to their test if you want to read more. The precise value depends on your boot size, weight and skiing level. Go here to calculate your DIN value.

For a detailed guide on changing bindings on snowboards read: How to Install Snowboard Bindings. Read Typically, most bindings are universal as long as the type of skiing you plan on doing matches both the boots and the bindings.

Readout article on ski bindings to find out bindings fit and where they do not. Vintage ski bindings from , photo by Ole Husby. I like the template as well as the centering ruler idea. I currently just use a blank piece of paper as described by Gobstopper. It works okay -- after creasing the centerline, I slide the paper up and down the ski and mark it. This process is usually pretty close, but I've had some end up way off. And yes, I always doublecheck. It probably doesn't help that I'm somewhat retarded when it comes to mechanical things.

Thanks everyone. Originally Posted by shasti. Join Date Feb Posts Mounted my first set of skis in the back of the hardware store I worked at in highschool. There was a drill press but I just used a hand drill with masking tape wrapped around it for a depth gauge. No template just used the mounting bracket to mark holes. Worked fine and is still holding strong though they don't get used much anymore. There are better ways to go about this but the point is that a little common sense and patience can yield good results.

Originally Posted by bite me. Texas is better than Hell? Maybe I'm not familiar enough with Hell, but it would be hard to imagine it being worse than Texas. Thanks a lot Alpinord and Mofro Does G1 indicate a drill bit size?

That is the only term on my Rocker2s that I can see as a possibility. Is there any way that the guide bit in the center of the tool can be swapped out so that the diameter can be changed?

I am looking to acquire a kit of tools that will help me take care of my own skis, so any suggestions on indispensable equipment would be welcome.

No drill press is needed for mounting ski bindings. Folding paper and marking only two points? Next candidate for "I fucked a mount" thread. Last Jump to page:. Regards, Joey. Obviously A snowHead isn't a real person. Spyderjon at thepisteoffice. Give him a shout. Well, the person's real but it's just a made up name, see? You need to Login to know who's really who. Yep Spyderjon will have the drill bits and the likes you need. Anyway, snowHeads is much more fun if you do.

What is the cost differential between buying the various tools you need and having it done professionally? You'll need to Register first of course. Quote: What is the cost differential between buying the various tools you need and having it done professionally?

Then you can post your own questions or snow reports After all it is free. Just follow carpentry rules measure tree times, drill once. You'll get to see more forums and be part of the best ski club on the net. I'm pretty handy at DIY but didn't dare do it myself Ski the Net with snowHeads. We do put a lot of business their way over the course of a winter.

And love to help out and answer questions and of course, read each other's snow reports. Get any binding mounted professionally, period. There's a list of obvious and legal reasons why. Hand tune your skis, yes.

Wax your skis, yes.