What is adapter fex

The channel can be thought of as a 'virtual link' on the physical link between the switch and server adapter. Port Profile the list of port profiles defined on the upstream Nexus can be selected. A virtual Ethernet interface will be automatically created on the Nexus if the Nexus is configured with the vethernet auto create command.

Note that only the virtual Ethernet port profile names port profile configuration is not are passed to the server. This occurs after the VNTag link connectivity is established and the initial handshake and negotiation steps are performed between the switch and server adapter. Power off and then power on the server again. Instead, they should be manually defined. The steps for the switch and server side are shown here. Complete these steps on the switch side: 1.

Create a virtual Ethernet trunk interface that is bound to the VNTag interface's channel of the server vhba interface. The virtual Ethernet numbers should be unique across the two Nexus switches. Create a VFC interface that is bound to the virtual Ethernet interface defined earlier. Example: config interface vfc10 config if bind interface veth 10 config if no shut. Power cycle the server. Verify Use this section to confirm that your configuration works properly. Time: Thu Apr 10 version 5. A vhba fixed virtual Ethernet needs an OS driver to bring this up wait until the OS loads the driver and boots up completely.

If the adapter is a Broadcom NIV adapter, check to see if the interfaces are up from the OS side for example, in Linux, bring up the interface 'ifconfig eth2 up'. See if any port profiles strings mismatch. For dynamic fixed virtual Ethernets, check the 'veth auto create' configuration. Log in to CIMC from a browser.

Click the Admin tab. Click Utilities. Updated: Sep 04, Document ID:. All rights reserved. This document is Cisco Public. This chapter includes the following. Days: 4 No. Days: 5 Contact us at: Telephone: You will become familiar. All Rights Reserved.

Brocade, Brocade Assurance, the B-wing symbol,. Aug 13, Contents Introduction Prerequisites. Note: This case study utilizes Packet Tracer. Use the. Configuring EtherChannel and Lab 3. Scenario A new switched network has. Using VLANs, you can enhance security and leverage. For more. Document Version 1. Operation of IP Data Networks Recognize the purpose and functions of various network devices such as Routers, Switches, Bridges and Hubs Select the components required to meet a given network specification.

Explain how to configure the NetVanta. Four switches have just been installed. The distribution layer switches are Catalyst. This allows the channel to connect a vNIC on the server with a Vethernet interface on the switch. The VIF allows the receiver to identify the channel that the source used to transmit the packet.

The following figures show topologies that are supported for server network adapters that support active-standby teaming of uplinks. The active-standby topologies shown here have one uplink as active and the other uplink as standby.

With some server network adapters, you can select the active and standby uplinks per vNIC. Logically, this actually allows the FEX host ports to show up on the parent switch and look, act, and feel just like physical ports on the parent.

The VN-tag acts like a virtual wire that connects the host port directly to the parent. Once again, the configuration of the virtual interfaces is performed on the parent switch. That, combined with the fact that all switching functions are performed in hardware on the upstream switch results in less CPU cycles on the host being taken up with processing packets.

With VM-FEX, the virtual and physical networks are merged and have a single point of management, policy control and traffic visibility. With integration to VMware vCenter, vMotion events can be signaled to the network so that the associated logical port on the parent switch retains its "stickyness" to the virtual machine and the appropriate vNIC resources are automatically instantiated on the new host.

Additionally, the VM vNIC profiles created by the network team on the parent switch are populated into vCenter which allows the virtualization team to select the network connectivity of a VM from a single drop down menu. Disclaimer : The opinions and information expressed in this blog article are my own and not necessarily those of Cisco Systems.