How to setup nat vmware workstation

->>>> Click Here to Download <<<<<<<-

On the Hardware tab, select Network Adapter. Click OK to save the changes. Username Password Remember Me. Configure NAT networking. Configure bridged networking Configure host-only networking. What is a guest operating system? Once you have installed it, it will be looks like the below image:.

By default, there are only two virtual network interfaces, i. If you are using Linux i. Ubuntu, Mint, etc. Click on the Add Network and make your virtual interface host only. After that, you have to provide the IP address. For example, I am going to use We will use the same file which was downloaded in step 1. You need to continue on the Typical option and click on the Next button.

Now, you need to select the pfSense Installer image, which was downloaded in step 1. If you want to change the default directory, you can change it. Now, you need to configure the disk for your pfSense VM. You can click on customize hardware to change it. Click on Customize Hardware and change it. First, you will find the Boot Menu, along with the pfSense logo. You need to continue on the boot process till you get copyright and distribution notice.

Now, you need to select the keymap during the installation process. Now, you need to do the partitioning of the disk. So, we are almost done here. It will take a few more minutes to complete the setup, obviously depends upon the system resources. Once, the installation process is completed, you will get the following screen.

After clicking on the reboot button, you will find that the pfSense firewall is getting a reboot, you will get the pfSense Logo, and finally a Welcome screen the same as per the given image. So, in this step, we have successfully installed pfSense in VMWare.

As we have configured two interfaces, i. In this example, my VM gets IP address