Deh-p4050ub user manual

For details concerning operation with the iPod adapter, refer to Playing songs on iPod on page Operation Manual.

Please read through these operating instructions so you will know how to operate. After you have finished reading the instructions, keep this man-. Use and care of the remote control. Introduction of audio adjustments. Setting the rear output and subwoofer. Entering PIN code for Bluetooth wireless. Displaying system version of Bluetooth. Turning the clock display on or off. Handling guideline of discs and player. Compressed audio files on the disc.

About this unit. Do not allow this unit to come into contact. Also, damage to this unit, smoke, and over-. Keep this manual handy as a reference for op-.

Always keep the volume low enough so that. If the battery is disconnected or discharged,. Windows Media and the Windows logo are tra-. Quick Links. See also: Service Manual , Operating Manual.

The use of. Install this unit away from hot places. When reattaching the trim ring,. If the trim ring is attached. This unit can be properly installed either from. For details, refer to the following. Insert the supplied extraction keys. Insert the mounting sleeve into the. If there is enough. Pull the unit out of the dashboard. Determine the appropriate position. Select a list that contains the songs.

Once the iPod main menu is displayed, connect the cable again. Therefore, in order to issue commands in a slave test, use the direct FUNCTION keys alternatively to enable the equal key command sending function to the existing models.

Offset is adjusted T. Remove the Cover and then remove the Keyboard Unit. Cover Fig. Hold the Upper and Lower Frames. Do not hold the front portion of the Upper Frame, because it is not very solid. Do not squeeze this area. Apply Shorting Solder to the flexible cable of the Pickup, and disconnect it from the Shorting Solder connector.

Unsolder the four leads, and loosen the Screw. Therefore, when replacing, be sure to use parts of identical designation.

Description Part No. Mark No. The encircled numbers denote measuring points in the circuit diagram. Reference voltage REFO1 1. The parts mounted on this PCB include all necessary parts for several destination.