Autodesk inventor bearing library

Did you mean:. This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service. Back to Inventor Category.

Back to Topic Listing Previous Next. Filter by Lables. Message 1 of 2. Important: Although Desktop Content can be shared across a network in a non-vault environment, permissions will have to be managed manually across the network. Desktop Content cannot be installed on a Vault server and shared across a network.

If you work in a shared environment, it is recommended you select Vault Server option when creating a deployment, and then install the server and the content center libraries from the Autodesk Vault Server media. The following is the list of content which can be installed with the Autodesk Inventor products. Note: Installs Content Center libraries directly on your local computer as Desktop content.

Note: To specify an install location for the Desktop Content libraries, click the Browse button. Topics in this section Install a Single-user Environment Reconfiguring the installation. Parent topic: Install Inventor on a Single Computer. If you decide to enter the filter dimensions, enter starting and ending values of the range.

You can enter the same value for starting and ending filter value. Before you click OK and insert bearings into an Autodesk Inventor assembly, you can switch to the Calculation tab to perform a calculation and strength check. The calculation is performed when you click Calculate. The beginning workflow can vary.

First, select the type of bearing, and then specify ranges for outside bearing diameter, shaft diameter, and bearing width. The selection of a shaft cylindrical face is the most logical because then the values for shaft diameter are inserted automatically in the Bearing Generator. You don't also need to specify all value ranges, for example, the bearing width. When a list of bearings is presented, you select the appropriate bearing. Bearing Tutorial. Insert bearings There are various ways to insert a bearing.

Note: You need to be connected to the Content Center server to be able to select bearings. Also, your Content Center must be configured. Note: We recommend you select Family.