Setup vpn windows xp behind router

In the details pane on the right-hand side, right-click the network interface that is connected to the Internet and select Properties. Click on Services and Ports tab. Click OK twice to close all boxes and exit the management console. Your users should be able to connect to the Cisco VPN now. There is no need to reboot the Windows Server Try These Solutions. Notify me of follow-up comments by email. Notify me of new posts by email. Post navigation Previous Post. Next Post. On December 27, Leave a Comment Cancel reply Your email address will not be published.

This div height required for enabling the sticky sidebar. We use cookies on our website to give you the most relevant experience by remembering your preferences and repeat visits. Manage consent. Close Privacy Overview This website uses cookies to improve your experience while you navigate through the website.

In the New Connection Wizard page, click Next. This allows other computers to connect to your Windows XP Professional-based computer by means of the Internet, a phone line, or a direct cable connection. On the Devices for Incoming Connections page, select the check box next to each device you want to use for incoming connections and then click Next. This enables a virtual private connection so that another computer can use the Internet or another public network to access your computer.

For this to occur, your computer must have a known name or an IP address on the Internet. This could be a static IP address, domain associated to a static IP address or domain associated to a dynamic IP address.

On the User Permissions page, select the check box next to each existing user name you want to add, or click Add for each new user you want to add. Click Next. This specifies the name of each user you permit to access your computer.

On the Networking Software page, select the check box next to each type of networking software that should be enabled for incoming connections. Click Next , and then click Finish. You will need to forward port from your router to the PC. Right click on Incoming Connections and select Properties. Please note that failing to specify the IP address range of incoming connections could result in failure to communicate with the Soundweb London devices.

This type of connection is easiest to set up and offers good if not the ultimate security. Open Network Connections. On the Network Connection Type page, click Connect to the network at my workplace, and then click Next as shown below.

On the Connection Name page, type the name of the connection or your company name, and then click Next.