Program uniden sportcat 180
Memory Bank Numbers — Each Memory Bank consists of 10 channels that you can select or deselect during scanning operation, using the numeric keypad. When you select a Bank, its number appears on the display. Page 11 3. HOLD appears on the display.
In Manual mode, press channel. Also use to access a channel directly with keys to select or deselect any of the 10 memory banks. Page 12 8. Use programming a frequency into a channel. When fully charged, this Battery Pack will supply up to 12 hours of dependable use. Place the Belt Clip on the mounting area on the back of the scanner, making sure the holes in the clip line up with the threads in the back of the scanner.
Insert the 2 screws into the corresponding holes and tighten. Before turning on the scanner, rotate the Squelch Control fully clockwise.
Turn the Volume Control a small amount clockwise to a low listening level. Page 16 Any channels that are not programmed When you select a frequency band to search, the scanner searches for any active frequency within the lower and upper limits of the band. Page Programming Channels Programming Channels Before you can scan, you must program the channels within a bank.
You can store one frequency per channel, up to channels. Note: If appears on the display keypad Locked , unlock the keypad by pressing and holding disappears. If you want to store the frequency in the selected channel 18 as well, press The frequency will blink twice to confirm the programming.
Use the keys or VFO control until you see the Band you want. Wait for at least 2 seconds or press Search to begin. If you wish to change the search direction, press and hold up or down direction.
Page Alert Beep Setting Note: If the frequency of the channel has not been programmed, you cannot program the Alpha Name on the channel. Turn clockwise to move 0 - 9, A - z and other characters and stop the control at the letter you wish to store. The indicators for the selected Banks 1 through 10 appear on the display. The indicator of the Bank currently being monitored flashes.
Page Priority Scan To access a specific channel: Press Enter the channel number using the numeric keys. Press again. Initially these are the first channel in each Bank. Channel 1, Channel 11, Channel 21, and so on. In priority scan mode, the scanner checks the Priority Channel s every 2 seconds during the Scan cycle. Page Locking Out Channels Locking Out Channels You may have programmed certain channels that you do not want to hear every time you scan.
These might be channels that are busy a major portion of the time, causing the scanner to stop at the channel s often enough to interrupt the scan cycle. You can search any of these Bands to find desired frequencies if you do not have a Frequency Directory handy, or if new stations have been added since the Directory was published. Page Search Skip Frequency Enter the higher limit of your search range.
Press Press appears on the display. In Manual mode, enter the frequency by using the number keypad and turnVFO control. Turn the scanner over so you are looking at the back. If the Belt clip is attached, remove it by taking out the two screws. Press in on the ribbed area and slide the Battery Cover down and off.
Do not use excessive amounts of water. You can program the Sportcat scanner to remember your most often listened to radio frequencies. Enter the frequency you want to program by pressing the corresponding buttons on the scanner's keypad, including the decimal point. For example, if you want to save frequency You will hear a beep if the same frequency is saved to another channel. The scanner will automatically scroll through frequencies in the band you chose and stop when it receives a signal.
This is the location of the first letter in the name.